100% airport grade and dries within hours. in stock ready to ship to your door. Save when buying a complete skid or more, instead of 1 drum at a time!As a property owner or contractor you want access to your asphalt surface as soon as possible after sealing. Our sealer makes this possible. Drying time is 3 to 4 hours.
This quality asphalt sealer can be sprayed with an Air Operated Spray System or applied with a sealer brush or squeegee.
As a sealcoating contractor you will have a MAJOR advantage over your competition when using Asphalt Kingdom's Sealcoating Sealer.
Your competition's sealer takes approximately 24 to 48 hours to dry. Asphalt Kingdom's Sealer takes 3 to 4 hours to dry. When you're talking to potential customers you can let them know about this. It provides a major sales conversion edge for you.
A 55-gallon drum of sealer will do six to eight 4-car driveways. Its coverage rate is 100 square feet per gallon.
*Please Note: Free shipping on our Sealer or Crackfiller does not apply to the following states: Washington, Oregon, California, Nevada, Arizona, Utah, Wyoming, Montana, Alaska or Hawaii. Please contact us for the best shipping rates to your area. 1-866-399-5562
Interested in purchasing more than 4 skids of sealer at a time? Call our Sales Experts and get a custom shipping quote and save hundreds!
We carry commercial-grade DOT spec sealer with a coverage rate of 100 square feet per gallon.
Temperatures must be 55 degrees or warmer for 3 hours after application for it to dry properly. Cure times will be longer in cooler conditions. The hotter it is, the faster the water evaporates from the sealer and the dry time can be as fast as 30 minutes. Try not to apply if hotter than 105°F.
Ideally sealer should dry for a couple of hours before it rains. It may need more time if it's very cloudy and humid.
There is no need for two coats, but if you're doing two coats, do them a week apart so the sealer has time to cure completely.
Asphalt is like a sponge which can only absorb so much sealer. Thicker isn't better if it doesn't get absorbed. We recommend between 25-30% dilution to get good even coverage at maximum efficiency.
The cause of this is over-agitating the sealer. Only recirculate your sealer for 2-3 minutes max at the beginning of the day and maybe for a minute at the beginning of each job.
You get this when the sealer is too thick and the pump cannot create a prime to circulate the sealer. Dilute it properly to achieve 20 to 30% water dilution.
Use a dipstick to check the level of your sealer at the end of the day and the next time you use your system, just in case of water evaporation (if the levels are different, add enough water to regain the previous sealer level).
Another possible reason could involve the system's ball valve. On the output part of the pump, there's a ball valve that allows you to redirect the sealer to the top of the tank or to the spray gun. If that ball valve is constantly or permanently broken to the spray gun, you wouldn't get recirculation.
Shipping Dimensions | 4' x 4' x 4' |
Weight | 2400 lbs |
Water % | 53 Max, 48 Min |
Non-Volatile % | 52 Max, 47 Min |
Ash % | 39 Max, 35 Min |
Sp. Gr. @ 77° | 1.29 Max, 1.19 Min |
Product Safety Data Sheet | Download here |